DSP stereo FM encoder & processor SE 5000 +

Volume discounts

Quantity	Discount	You Save
2	2%	Up to € 5,78
4	4%	Up to € 23,14
6	6%	Up to € 52,06
8	8%	Up to € 92,56
10	10%	Up to € 144,62

More info About: DSP stereo FM encoder & processor SE 5000 +

 

Professional DSP stereo encoder & processor SE 5000




 

 

Product Discription: Improved SE5000 DSP+ Improved stereo separation I2C connector was redesigned for standard flat cable, now installation does not require any soldering but merely plugging a 6-pin flat cable into LCD module and stereo encoder. A number of small improvements that bring out better sound! I2C buffers permit for longer I2C cable and eliminate the notorious I2C error

Technical Facts: Audio Response: 10Hz-15KHz, DSP filtered (Standards require upper level at 15KHz) DSP: 24-bit Digital Signal Processor 19KHz notch filter, >-70 dB typ Precise pre-emphasis, 50uS, 75uS or none Audio Input Impedance: 10Kohm, balanced or unbalanced Audio Input Level: 0 dB Distortion: <0.1% S/N ratio: >80 dB Separation: >70 dB typ. (more than any radio receiver you can buy on the market) Pilot Frequency: 19 KHz, DSP generated 32x oversampling Output Impedance: 75 Ohms Power Requirements: 12-15VDC / 160-200mA PC Board Size: 100x85mm Audio connectors: all RCA jacks are mounted on the board, 3-pin jumper for XLR balanced input, optional MCX or solder pads for MPX output Power connector: 2.1mm power socket, center (+) and screw terminals (easier for boxed units) Output level: Ueff 4V, 2V or 1V

 

 

Accessories