Op DMR-Electronics maken wij gebruik van cookies en andere technologieën, als u verder gaat accepteerd u de cookies close
SE 6000 FM stereo encoder DSP (voor inbouw FM Zender) Bekijk groter

SE 6000 FM stereo encoder DSP (voor inbouw FM Zender)

SE6000-st-DS

Niet op voorraad

Stereo encoder series with record-breaking 114x oversampling

Meer details


✓ Scherpe prijs ✓ Veilig betalen
✓ Gratis verzenden ✓ Niet goed geld terug
✓ Volume korting ✓ Korting sparen
✓ Groot assortiment ✓ QShops Keurmerk

Bij het kopen - bestellen van dit product krijgt u in totaal 11 Loyaliteit punten. Uw winkelwagen bevat een totaal aan 11 Loyaliteit punten die omgezet kunnen worden in een waardebon van EUR 2,20.


EUR 234,99 incl. BTW

Volumekorting

Aantal Prijs U bespaart
5 EUR 225,59 Tot EUR 47,00
10 EUR 213,84 Tot EUR 211,49

Accessoires

Meer informatie

Stereo encoder series with record-breaking 114x oversampling

 
Product Discription:
SE6000 series stereo encoders feature a number of big enhancements and raise the bar considerably for stereo separation and audio excellence. The amazing sonic purity and clarity are sure to impress you. The new MPX multiplexer circuit is 114x oversampled and gives better stereo separation than anything else in its price range and beyond. Additional digital audio input completely eliminates any ground-loop problems. Lets not forget the new telemetry output (interfaces to MAX PRO 5000 FM exciter, if you choose to use it - its optional). The new SE6000 series stereo encoders comes in a new bigger form factor that differs from the previous SE2000, 3000, 4000 and 5000 models. There are two models in the SE6000 series, the so far listed enhancements are common for both versions. You can read about the differences between the two models below:

Model DSP+
- Stereo encoder with DSP audio processor
- DSP technology with multi-band limiter and multi-band compressor
- Extremely sharp low pass filters with deep 19KHz notch
- Works with or without LCD control module, LCD gives you a number of settings!
- Can be connected to our MAX PRO 5000 series FM exciters and controlled from its LCD module.
- Precision LC filtered MPX output signal

Model AN+
- Analog stereo encoder with very sharp solid-state LC analog filters
- Single-band limiter 
- Deep 19KHz notch
- Precision LC filtered MPX output signal
- LCD not needed (there is nothing to control, no DSP processor available on board) 





 
Technical Facts:
  • Audio Response: 10Hz-15KHz, DSP or LC filtered (as per CCIR standards)
  • DSP: 24-bit Digital Signal Processor, Analog: LC filters
  • 19KHz notch filter, >-70 dB typ
  • Precise pre-emphasis, 50uS, 75uS or none
  • Audio Input Impedance: 10Kohm, balanced or unbalanced
  • Audio Input Level: 0 dB
  • Distortion: <0.1%
  • S/N ratio: >90 dB
  • Separation: >75 dB typ. (more than any radio receiver you can buy on the market)
  • Pilot Frequency: 19 KHz, 114x oversampled MPX
  • Output Impedance: 75 Ohms
  • Power Requirements: 12-15VDC / 160-200mA
  • PC Board Size: 100x110mm
  • Audio connectors: all RCA jacks are mounted on the board, 3-pin jumpers for XLR balanced inputs, optional MCX or solder pads for MPX output
  • Power connector: solder pads
  • Output level: Ueff 2V
     

 

 

Recensies

Schrijf uw recensie

SE 6000 FM stereo encoder DSP (voor inbouw FM Zender)

SE 6000 FM stereo encoder DSP (voor inbouw FM Zender)

Stereo encoder series with record-breaking 114x oversampling

Schrijf uw recensie

Klanten die dit product aangeschaft hebben kochten ook...

7 Andere producten in dezelfde categorie: