CyberMax-8000+ DSP-RDS stereo RDS processor

Product discription:

CyberMax-8000+ DSP stereo encoder offers excellent stereo separation with 114x oversampling, RDS and DSP. Based on our latest SE8000 DSP+ with built-in compressor, limiter, balanced inputs, sharp 19KHz stereo carrier notch filter, pre-emphasis, LC input filters and ESD protected inputs which all help to bring out the best sound. Perfect for a demanding, but cost-conscious broadcaster. DSP filters and others all make this encoder a real bargain. This is your perfect gateway into the world of excellent stereo separation and sound!

Technical facts:

• Audio Response: 10Hz-15KHz, DSP or LC filtered (as per CCIR standards)
  - DSP: 24-bit Digital Signal Processor, Analog: LC filters
  - 19KHz notch filter, >-60 dB typ
  - Precise pre-emphasis, 50uS, 75uS or none
  - Audio Input Impedance: 10Kohm, balanced or unbalanced
  - Audio Input Level: 0 dB
  - Distortion: <0.1%
  - S/N ratio: >90 dB
  - Separation: >60 dB typ. (much more than typical radio receivers can resolve)
  - Pilot Frequency: 19 KHz, 114x oversampled MPX
  - Output Impedance: 75 Ohms
  - Power Requirements: 12-15VDC / 200mA
  - PC Board Size: 100x120mm
  - Audio connectors: all RCA jacks are mounted on the board, 3-pin jumpers for XLR balanced inputs, optional MCX or solder pads for MPX output
  - Power connector: solder pads
  - Output level: Ueff 1-4V adjustable with trimmer
• RDS encoder will work independently from the PC (memory stays unchanged for at least 45 years after power-off, RTC 10-14 days)