SE 6000 FM stereo encoder Analoge

    SE6000-st-AN

          New

              Stereo encoder series with record-breaking 114x oversampling

            More details

          By buying this product you can collect up to 7 loyalty points. Your cart will total 7 loyalty points that can be converted into a voucher of € 1,40.


                € 152,88

                Discount on your order Discount on your order
                 Free shipping to NL
                 Volume discount
                 Bonus system
                 Safe to Pay
                 Money back guarantee
                 QShops certification
                Trustpilot Trustpilot

        Volume discounts

          Quantity Discount You Save
          2 2% Up to € 6,12
          4 4% Up to € 24,46
          6 6% Up to € 55,04
          8 8% Up to € 97,84
          10 10% Up to € 152,88

        More info SE 6000 FM stereo encoder Analoge

          Stereo encoder series with record-breaking 114x oversampling

           
          Product Discription:
          SE6000 series stereo encoders feature a number of big enhancements and raise the bar considerably for stereo separation and audio excellence. The amazing sonic purity and clarity are sure to impress you. The new MPX multiplexer circuit is 114x oversampled and gives better stereo separation than anything else in its price range and beyond. Additional digital audio input completely eliminates any ground-loop problems. Lets not forget the new telemetry output (interfaces to MAX PRO 5000 FM exciter, if you choose to use it - its optional). The new SE6000 series stereo encoders comes in a new bigger form factor that differs from the previous SE2000, 3000, 4000 and 5000 models. There are two models in the SE6000 series, the so far listed enhancements are common for both versions. You can read about the differences between the two models below:

          Model DSP+
          - Stereo encoder with DSP audio processor
          - DSP technology with multi-band limiter and multi-band compressor
          - Extremely sharp low pass filters with deep 19KHz notch
          - Works with or without LCD control module, LCD gives you a number of settings!
          - Can be connected to our MAX PRO 5000 series FM exciters and controlled from its LCD module.
          - Precision LC filtered MPX output signal

          Model AN+
          - Analog stereo encoder with very sharp solid-state LC analog filters
          - Single-band limiter
          - Deep 19KHz notch
          - Precision LC filtered MPX output signal
          - LCD not needed (there is nothing to control, no DSP processor available on board)





           
          Technical Facts:
          • Audio Response: 10Hz-15KHz, DSP or LC filtered (as per CCIR standards)
          • DSP: 24-bit Digital Signal Processor, Analog: LC filters
          • 19KHz notch filter, >-70 dB typ
          • Precise pre-emphasis, 50uS, 75uS or none
          • Audio Input Impedance: 10Kohm, balanced or unbalanced
          • Audio Input Level: 0 dB
          • Distortion: <0.1%
          • S/N ratio: >90 dB
          • Separation: >75 dB typ. (more than any radio receiver you can buy on the market)
          • Pilot Frequency: 19 KHz, 114x oversampled MPX
          • Output Impedance: 75 Ohms
          • Power Requirements: 12-15VDC / 160-200mA
          • PC Board Size: 100x110mm
          • Audio connectors: all RCA jacks are mounted on the board, 3-pin jumpers for XLR balanced inputs, optional MCX or solder pads for MPX output
          • Power connector: solder pads
          • Output level: Ueff 2V
             

           

           

           

        Accessories

        6 other products in the same category:FM Stereo Encoders