Fm Transmitter peripherals, find here everything you need to repair, expand your transmitter equipment. All resources in one place.
These high power RF attenuators are typically used for construction of RF amplifiers and other RF devices. For values not listed drop us an e-mail and ask. Attenuators have 2 leads and are bolted to the heatsink with grounding flange, this flange also represents signal ground.
If you need other types please contact us for more..
Soldering station, 48W, especially suitable for lead-free soldering according to EU directive (RoHS)
RF output board 1500W for N or SO239 connector with SWR/PWR directional coupler. Now with TEFLON laminate and frequency compensated inside FM broadcasting band!
Low Pass Filter FM Broadcast teflon 2000W 86-110MHz 9th order Chebyshev typology Ultra low loss Teflon PCB; tightly controlled dielectric constant large #8 awg inductors 0.12 dB insertion loss maximum; 0.1dB typical 23dB return loss; -25dB typical -45dB rejection at 176MHz. That's the 1st harmonic of 88MHz Measures 11 inches long x 3 inches wide For...
3M ™ MDT-A is a medium-thick, flexible, wear-resistant shrink tubing with a hot-melt adhesive. This shrink tube is widely used in heat shrink sleeves and provides a good seal against moisture. 3M ™ MDT-A meets the requirements of VDE 0278 part 3. The adhesive layer is especially suitable for applications such as underground cable sleeves.
Gaffer Tapes Width: 50mm, length: 50m